FCC Information to User¶
This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals
FCC Guidelines for Human Exposure¶
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC Declaration of Conformity¶
We LumenRadio AB Svangatan 2B, 41668 Gothenburg, Sweden, declare under our sole responsibility that 800-8105, TiMo RX RDM and 800-8106, TiMo FX RDM, comply with Part 15 of FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Warnings & Instructions¶
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the product, unless expressly approved by LumenRadio AB., could void the user’s right to operate the equipment.
Industry Canada statement¶
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le resent appareil numerique német pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le broullage radioélectrique édicté par le ministére des Communications du Canada.
800-8105 TiMo RX RDM and 800-8106 TiMo FX RDM comply with the Essential Requirements of RED (Radio Equipment Directive) of the European Union (2014/53/EU). TiMo RX RDM and TiMO FX RDM meet the ETSI EN 300 328 V1.8.1 and ETSI EN 300 328 V1.9.1 conformance standards for radio performance.
FCC & Industry Canada¶
The CRMX modules are certified for FCC as a single-modular transmitter.
CRMX modules are FCC certified radio module that carries a “Modular” grant CRMX radio modules complies to the “Intentional Radiator” portion (Part 15c) for FCC certification: Part 15.247 Transmitter tests.
An end product, incorporating a CRMX module, does not require additional testing or authorization for the CRMX transmitter (or transceiver, in the case of RDM or Flex products). Host end products can use the FCC ID of the certified module as the FCC ID of the host end product. A label displaying the CRMX module’s FCC ID must be affixed and visible on the host end product for approval
FCC IDs are required for host end products with radio transmitters.
For other local compliance regulations (CE, UL, CSA, SRRC, C-Tick, etc.) you are responsible as the product manufacturer to ensure all required compliance testing is completed. LumenRadio are happy to advise on compliance testing – please contact LumenRadio for details.